How to Reset Your Garage Door Code in 60 Seconds

This article is written by Kristy Jones of aclickawayremotes.com a Garage Door Opener Store.

Reset Your Garage Door CodeThere will be times when your garage door suddenly does not work or is suddenly reset. When this happens, you must reset your garage door opener code to get things working again. In addition to that, stolen remotes also require you to reset your garage door opener.

Resetting your garage door opener code is an essential knowledge for every homeowner. There will always be situations where this will come in handy. Don’t worry, this is fairly simple and can be done in a minute.

Note that different garage door openers are reset differently. This depends on the type of garage door opener that you have and its manufacturing date. Here are the steps to follow in resetting your garage door within 60 seconds:

Garage Door Openers with Keypads

If your garage door opener has a wall-mounted keypad, then follow these steps to reset its code:

  • Get a ladder. Use a ladder to reach the motor of your garage door opener unit.
  • Locate the learn button. This is button is usually found at the back of the motor near the antenna. Press this button and release it only when the LED light goes out. When it does, the old code has been removed from its memory.
  • Press the learn button for the new code. Press the button again and the light will come on. Within 30 seconds, enter your new code on your keypad. Avoid using your birthday or 1-2-3-4 as codes. These are too common and can easily be decoded by anyone. The LED light will blink again to signify that the new code is already programmed into the device. Never share this code to anyone else to keep your home secure at all times.
  • Program the remote. After this, you can already program your garage door opener remote. Press the learn button on your garage door opener. The LED light will go on again. Within a few seconds, press the preferred button on your remote control. Repeat this step if you have other remotes left to program.
  • Test it out. Test the keypad and the remote if both activates the garage door opener. If it doesn’t, you might need to repeat the above steps to reset the code.

Garage Door Openers without a Keypad

If your garage door opener does not have a keypad, do the following to reset your code:

  • Locate the switches. Remove the cover on your garage door opener remote to find the switches.
  • Change up the switches. Reposition the dip switches on the remote to change the code. Do not use common combinations for your code. Be as creative and as usual as you get.
  • Repeat the above steps. Replace the cover on the remote control and repeat the steps above for other remote controls.
  • Copy the new code on the device. Once you have successfully changed the combinations on your remote, match the combination on your garage door opener unit. You may need a ladder to reach the back of your garage door opener unit.
  • Test it. After changing the switches on both the remote and the garage door opener, test if the code has been successfully reset. Test the remote. If it does not respond, the switch positions might not be properly matched. Check it and retest the remote again.

You might want to reset your garage door opener code from time to time to improve your home’s security, as well. Resetting the code is not just necessary for times when the remote or device is hacked. This prevents anyone to get inside your home too easily. You can schedule this every few months just to add an extra layer of security to your garage.

Leave a Reply